VeeBath Toilet Inlet Valve Bottom Entry, Inlet Float Valve 1/2 inch

Easy to fit quick fill and adjustable height and stop level also is fitted with a water filter. Takes about 10min to fit no need to remove tank if it’s only the inlet your fitting.

Very easy, the brass fitting is good quality and I'm sure it will last a long time. Very quiet when filling

After taking completely apart and putting back together, the valve worked.

I bought this particular style of valve to replace an old style ball arm type as part of a complete refurbishment of the bodge up from hell (see photo) . The new valve now sits in splendid isolation on the left hand side of the cistern with the water inlet changed to suit and the previous right side entry hole blanked off.Initially I looked at other valves costing twice as much and thought that perhaps this one wouldn’t be so good but went ahead and bought it anyway. Surprisingly it is pretty well made and is supplied with a decent idiot proof cone shaped rubber sealing washer. Not sure if the stem is actually brass or brass finish . Hopefully it is plated copper and not DinkyToy alloy . The instructions are pretty basic and do not explain fully how to adjust the height of the stem . This is done by twisting and unlocking , sliding to size and then twisting back to lock and is probably best done before fitting. Only grip the shaft when twisting as the working parts are less robust and will probably break off. The packaging says it’s designed in the UK and made in China (what isn’t) . Anyway if it’s as good as my I-Pad I won’t worry.The inlet is fitted with a removable filter with regular cleaning advised so I suspect this and others of the type are susceptible to dirt or debris so perhaps worth paying attention to . The metal connection , unlike plastic should stand up to routine maintenance .Suitable for low and high pressure without the need for restriction inserts and on my 3 bar mains fills in seconds and is particularly quiet, unlike its predecessor mimicking a hose pipe filling a bucket and dripping encore.Instructions do not include any reference to dismantling the top end for washer replacement etc , but considering you might have to pay £3-4 for the washer alone what would be the point, better to get another valve .

Like for like replacement of the old valve at a good price. Easy to fit and working fine.

works! :)

This is good gear. The height of the float can be set by lengthening the stem before installing and / or by a screw once installed. Works very well.Just check nothing could the instalation. In my case had to adjust my flush mechanism to avoid the unit. Better than a cock and ball if nothing fouls. Will buy again. Hope this helps.

Usual plastic, made in China. Been used now for some months and working satisfactory